prohibited list is one of those subjects where the details matter more than the headlines. This page pulls together the background, the mechanisms, and the practical points readers ask about most.
Updated 2025-12-04. Numbers and descriptions here follow the published literature rather than marketing material.
Several names appear in scientific and commercial contexts for this peptide. The label TB-500 is informal and does not follow standard biochemical nomenclature. Research articles more often describe the compound as a thymosin beta-4 fragment, Tβ4 fragment, or by its sequence Ac-LKKTETQ. Confusing TB-500 with full-length thymosin beta-4 can lead to incorrect assumptions about activity because the fragment lacks the remaining residues of the parent protein. The relationship between fragment and parent protein remains an active area of study.
Regulatory status differs by country, but TB-500 is not an approved pharmaceutical in major jurisdictions. It is commonly sold as a research chemical for laboratory use, which places responsibility for identity and purity on the supplier and the laboratory. Published human data are limited, and most reports involve preclinical models or cell culture. Questions about whether the fragment mimics all actions of thymosin beta-4, and under which conditions, remain open. Independent verification of any material is therefore a practical requirement in research settings.
TB-500 is a synthetic heptapeptide with the sequence Ac-LKKTETQ. It corresponds to a short N-terminal region of thymosin beta-4, a 43-amino-acid protein found in many cell types. The fragment contains an actin-binding motif, which is one reason it appears in laboratory studies of cell migration and cytoskeletal dynamics. TB-500 is not the full-length protein and is produced as a research chemical rather than an approved therapeutic agent. Its molecular weight is approximately 889 Da.
Material is normally supplied as a lyophilised powder in a sealed vial. The powder is hygroscopic, so exposure to humid air leads to water uptake, caking and gradual loss of the fluffy texture that indicates a good freeze-dry. Vials are best kept sealed with desiccant, protected from light and stored cold. Letting a cold vial warm to room temperature before opening reduces condensation on the contents. Purity is normally reported from a chromatographic run, and that figure applies to the batch as tested rather than to the vial after repeated opening.
Once dissolved, the peptide is far less stable than the dry powder. Aqueous solutions are subject to hydrolysis, oxidation at susceptible residues and gradual loss of material through adsorption onto glass and plastic surfaces. Terminal glutamine can cyclise under some conditions, producing a related species that complicates purity assessment. Dilute solutions tend to lose a larger fraction of material to surfaces than concentrated ones. Buffers, pH and ionic strength all influence the rate of change, so stability figures are only meaningful when those parameters are stated alongside the storage interval.
Detection in biological samples relies on mass spectrometry, typically liquid chromatography coupled to tandem mass spectrometry after peptide extraction and enrichment. Intact peptides can also be confirmed by high-resolution mass measurement together with fragmentation data. Detection windows in urine are short because the peptide is degraded by proteases and cleared quickly, and concentrations are low. Many jurisdictions treat the compound as a prohibited substance in sport, grouped with peptide hormones and related factors, while it is not an approved therapeutic product. Identity and purity statements therefore rest on certificates of analysis, ideally issued by an independent laboratory.
| Property | Value | Notes |
|---|---|---|
| Molecular formula | C38H68N10O14 | Calculated for the acetylated heptapeptide |
| Molecular weight | ~889 Da | Monoisotopic mass approximately 889.0 Da |
| Amino acid sequence | Ac-LKKTETQ | N-terminal acetylated seven-residue peptide |
| Appearance | White to off-white powder | Typically supplied as a lyophilized solid |
| Solubility class | Water-soluble | Peptides of this size generally dissolve in aqueous media |
TB-500 is a short synthetic peptide sold under a trade name rather than a systematic chemical name. Suppliers usually describe it as a fragment of thymosin beta-4 and ship it as a lyophilised powder intended for laboratory use. Because the label is commercial, the exact sequence attributed to it is not fully consistent across catalogues, and some listings present a seven-residue peptide while others describe related fragments of similar length. It is not an approved medicine in any major jurisdiction, and it is handled as a research chemical.
Thymosin beta-4 itself is a natural peptide of 43 residues found in many cell types and body fluids. Its best-characterised function is binding and sequestering actin monomers, which influences cytoskeletal dynamics. The sequence most often associated with TB-500, LKKTETQ, corresponds to part of that actin-binding region. A different fragment, Ac-SDKP, is also derived from the same parent peptide and is studied in its own right, which is one reason discussions of thymosin fragments can become confusing. The two are structurally distinct and are not interchangeable.
Interest in the fragment grew during the 1990s and 2000s, when it moved from laboratory work into sports and supplement markets. Anti-doping bodies added thymosin beta-4 fragments to prohibited lists, and a small number of adverse analytical findings have been reported in competition testing. Published controlled human trials remain scarce. Most mechanistic evidence comes from cell culture and animal models, and those studies examine endpoints such as cell migration, wound closure and inflammation markers. That evidence supports research interest but does not establish clinical benefit, and broad regenerative claims should be read as unverified.
Purity and identity are separate measurements and are often confused. Reverse-phase high-performance liquid chromatography, usually with ultraviolet detection near 214 nanometres, reports the share of total peak area belonging to the target compound. Mass spectrometry by electrospray or matrix-assisted laser desorption then checks whether the observed mass matches the expected sequence. Neither measurement alone shows that a vial holds the intended peptide. Peptide content, meaning the fraction of vial mass that is genuine peptide rather than counter-ion, water or residual acid, is reported separately and is frequently lower than the stated purity figure.
The regulatory position is broadly consistent across major jurisdictions: no thymosin beta-4 fragment is an approved medicine, and laboratory material is commonly labelled as not intended for human consumption. Anti-doping rules in sport list thymosin beta-4 and its fragments among prohibited peptide hormones. Because these products travel through research-chemical channels rather than pharmaceutical supply chains, quality varies considerably between vendors. Independent testing of identity, purity and sterility is the only dependable check, and a certificate of analysis describes one batch rather than a supplier's whole catalogue.
Research interest in thymosin beta-4 fragments centres on actin sequestration, cell migration and tissue repair models. Most published work uses cultured cells or animal wound and cardiac preparations, and findings are generally described as preliminary. No fragment of this protein has been approved as a therapeutic product by major regulators. Reviews of the field note inconsistent dosing, delivery routes and outcome measures across studies, which complicates direct comparison. The material is best understood as a laboratory reagent with an active but unresolved research literature.
TB-500 is a catalogue name applied to a synthetic peptide related to thymosin beta-4, an actin-binding protein found in most mammalian cells. Suppliers do not use the label consistently: some describe it as the full 43-residue protein, others as a short fragment from the actin-binding region, and others as a related tetrapeptide. Because the name is commercial rather than chemical, two products sold under it may not contain the same molecule. This naming ambiguity is the first point to check in any description of the material.
The most frequently cited identity is a seven-residue fragment with the sequence LKKTETQ, taken from the actin-binding domain of the parent protein. A separate molecule, N-acetyl-seryl-aspartyl-lysyl-proline, often shortened to Ac-SDKP, derives from the same protein's N-terminal region and appears in overlapping literature. Reported molecular masses therefore differ between sources, and a mass value on its own does not establish which fragment is present. Confirmation requires a defined sequence rather than a single number.
== Mechanism of action == Delta atracotoxin is responsible for the potentially lethal envenomation syndrome seen following funnel-web spider envenomation. d-Atracotoxins induce spontaneous, repetitive firing and prolongation of action potentials resulting in continuous acetylcholine neurotransmitter release from somatic and autonomic nerve endings. This will lead to slower voltage-gated sodium channel inactivation and a hyperpolarizing shift in the voltage-dependence of activation. This action is due to voltage-dependent binding to neurotoxin receptor site-3 in a similar, but not identical, fashion to scorpion a-toxins and sea anemone toxins. In the sea anemone and scorpion toxins, combinations of charged (especially cationic) and hydrophobic side-chains are important for binding to their receptor site (site 3) on the sodium channel. The same applies to delta atracotoxin and versutoxin (a close homologue of delta atracotoxin). Delta atracotoxin presents three distinct charged patches on its surface, as well as a non-polar region centered on the 22-28 loop. Both of these structural features may play a role in its binding to the voltage-gated sodium channel, but further studies are necessary in defining which residues are important for interaction with the sodium channel so that a plausible model can be constructed of its binding site.
{\displaystyle {\begin{aligned}V=\left[H_{0}^{1}(\Omega )\right]^{d}&=\left\{\mathbf {v} \in \left[H^{1}(\Omega )\right]^{d}:\quad \mathbf {v} =\mathbf {0} {\text{ on }}\Gamma _{D}\right\},\\Q&=L^{2}(\Omega )\end{aligned}}}
Students enrolled in introductory animal science courses at many universities learn animal science through collections of multispecies large-animal specimens. Plastination allows students to have hands-on experience in this field, without exposure to chemicals such as formalin. For example, plastinated canine gastrointestinal tracts are used to help in the teaching of endoscopic technique and anatomy. The plastinated specimens retain their dilated conformation by a positive pressure air flow during the curing process, which allows them to be used to teach both endoscopic technique and gastrointestinal anatomy. With the use of plastination as a teaching method of animal science, fewer animals have to be killed for research, as the plastination process allows specimens to be studied for a long time. TTT sheet plastinates for school teaching and lay instruction provide an impression of the complexity of an animal body in one specimen.
Sources: en.wikipedia.org
Tidepool Web — a data visualisation platform that aggregates data from a wide range of diabetes devices, including insulin pumps, continuous glucose monitors and blood glucose meters, allowing users and clinicians to review trends over time. Tidepool Mobile — a companion mobile application for logging meals, exercise and other contextual information alongside device data. Tidepool Loop — an open-source automated insulin delivery system that links a compatible continuous glucose monitor with an insulin pump to automate basal insulin dosing based on glucose readings. Tidepool Loop received FDA 510(k) clearance, making it the first FDA-cleared open-source AID application.
=== Selective labeling and tracking of biomolecules === Click chemistry is often employed to attach visualizing tags. In many potential applications, click reactions join a biomolecule and a reporter molecule or other molecular probe, a process called bioconjugation. The possibility of attaching fluorophores and other reporter molecules has made click chemistry a tool for identifying, locating, and characterizing biomolecules. One of the earliest and most important methods in bioconjugation was to express a reporter gene, such as the gene green fluorescent protein (GFP), on the same genetic sequence as a protein of interest. Examples of bioconjugation for labelling include the use of azidocoumarin to label alkyne groups in modified proteins and biomolecules. The fluorophore rhodamine has been coupled onto norbornene, and reacted with tetrazine in living systems. In other cases, SPAAC between a cyclooctyne-modified fluorophore and azide-tagged proteins allowed the selection of these proteins in cell lysates.
== Early life and education == Klaus Mosbach was born in Leipzig, Germany. Family status: Married to May E., three daughters (Petra, Katja, Vanja). Klaus Mosbach went to school in Leipzig Germany and Lund, Sweden, In 1952 he moved to London, where he took Cambridge and interpreter exams. After working in a pharmaceutical company, Ferrosan in Malmö, Sweden, he began his university studies at Lund University 1953. In 1956 he took his master's degree in chemistry and biology and subsequently in 1960 his Ph.D. in biochemistry with a thesis on "the biosynthesis of aromatic compounds in fungi and lichens". He was then awarded the Waksman-Merck post-doctoral fellowship and stayed for 1.5 years at the Institute of Microbiology, Rutgers University, N.J., USA... In 1962 he developed, jointly with Dr. Schaffner in the Philippines, a pasteurization process against Salmonella infections in coconuts, which subsequently was approved by the Food and Drug Administration and is presently used. After returning to Sweden, he continued his studies on secondary metabolism. He received his second Ph.D. (corresponding to associate professorship or "Habilitation") from the University of Lund in 1964. Until 1970 he was associate professor there, and from 1970 onwards he has been full professor and head of the Department of Pure and Applied Biochemistry, which he founded, at Lund Institute of Technology. He also co-founded the Department of biotechnology at the Swiss Federal Institute of Technology ETH Zurich, Switzerland, in 1982.
Sources: en.wikipedia.org
TB-500 is a synthetic heptapeptide corresponding to a fragment of thymosin beta-4. It is used in laboratory research and is not an approved drug.
No. Thymosin beta-4 is a 43-amino-acid protein, while TB-500 represents only a short N-terminal segment. The two should not be treated as interchangeable in experimental design.
It is often called a thymosin beta-4 fragment, Tβ4 fragment, or Ac-LKKTETQ. The name TB-500 is mainly a commercial or catalog label rather than a formal chemical name.
Sealed, dry and protected from light at reduced temperature is the usual laboratory convention. Allowing a cold vial to reach room temperature before opening limits condensation. Repeated opening exposes the powder to moisture and should be minimised.