The short version of lyophilised powder fits in a sentence. The long version — which is the one that helps — is below.
Reviewed 2026-06-19. Anything still debated is marked as such rather than presented as settled.
Thymosin beta-4 itself is a natural peptide of 43 residues found in many cell types and body fluids. Its best-characterised function is binding and sequestering actin monomers, which influences cytoskeletal dynamics. The sequence most often associated with TB-500, LKKTETQ, corresponds to part of that actin-binding region. A different fragment, Ac-SDKP, is also derived from the same parent peptide and is studied in its own right, which is one reason discussions of thymosin fragments can become confusing. The two are structurally distinct and are not interchangeable.
Interest in the fragment grew during the 1990s and 2000s, when it moved from laboratory work into sports and supplement markets. Anti-doping bodies added thymosin beta-4 fragments to prohibited lists, and a small number of adverse analytical findings have been reported in competition testing. Published controlled human trials remain scarce. Most mechanistic evidence comes from cell culture and animal models, and those studies examine endpoints such as cell migration, wound closure and inflammation markers. That evidence supports research interest but does not establish clinical benefit, and broad regenerative claims should be read as unverified.
TB-500 is a short synthetic peptide sold under a trade name rather than a systematic chemical name. Suppliers usually describe it as a fragment of thymosin beta-4 and ship it as a lyophilised powder intended for laboratory use. Because the label is commercial, the exact sequence attributed to it is not fully consistent across catalogues, and some listings present a seven-residue peptide while others describe related fragments of similar length. It is not an approved medicine in any major jurisdiction, and it is handled as a research chemical.
Lyophilised peptide powders are hygroscopic, and the fragment absorbs atmospheric moisture when a vial is opened at room temperature. Weighing and aliquoting are normally done quickly in a dry environment, and stock solutions are divided into single-use portions before freezing. Repeated freeze-thaw cycles are avoided because they promote aggregation and can shift the measured content of a vial. These practices are general to synthetic peptides rather than unique to this sequence, but they matter more for short chains kept for long periods.
The seven-residue chain carries several polar and charged side chains, so it dissolves readily in water and in aqueous buffers near neutral pH. No cysteine is present, so disulphide formation is not a concern and reducing agents are unnecessary. Dilute ammonium hydroxide or acetonitrile-water mixtures are sometimes used for stock solutions when initial dissolution is slow. Strongly alkaline conditions and prolonged contact with oxidising agents are avoided because they can modify lysine-containing stretches, and haze in solution usually signals incomplete dissolution or aggregated material.
Identity and purity are checked with reversed-phase high-performance liquid chromatography, which separates the target sequence from truncated or deletion analogues, and with mass spectrometry, which confirms the expected molecular mass. Amino acid analysis and peptide mapping give orthogonal confirmation but are used less often outside specialist laboratories. Counter-ion content varies: material purified on trifluoroacetic acid gradients retains trifluoroacetate, and ion exchange can convert the salt form. Residual water and solvent are measured by Karl Fischer titration or thermogravimetric analysis, and any purity figure should be read together with the method used to obtain it.
| Property | Value | Notes |
|---|---|---|
| Name type | Commercial trade name | Not a systematic chemical identifier |
| Parent peptide | Thymosin beta-4 | 43-residue natural peptide |
| Common fragment sequence | LKKTETQ | Maps to part of the actin-binding region |
| Molecular size class | Roughly 0.8-1.0 kDa | Depends on exact fragment and terminal modification |
| Regulatory status | Prohibited in sport | Grouped with peptide hormones in many frameworks |
Storage recommendations center on keeping the dry powder cold, dry, and dark. A freezer at -20 degrees Celsius or below is conventional, and desiccant is often included to limit moisture uptake. Once dissolved, the peptide is less stable, and solutions are typically kept frozen and thawed only once. Repeated freeze-thaw cycles are a common source of losses because they promote aggregation and adsorption to container surfaces. Working aliquots are therefore prepared in advance, and glass or low-binding plastic is usually preferred over ordinary laboratory plastic.
Identity and purity are assessed with a small set of standard techniques. Reverse-phase high-performance liquid chromatography gives a purity estimate from peak area, usually recorded at 214 or 220 nanometers, where the peptide bond absorbs. Mass spectrometry confirms the expected molecular mass and can reveal truncated or oxidized species. Amino acid analysis or tandem mass spectrometry sequencing can verify the sequence itself. Additional quality attributes include water content, residual trifluoroacetic acid carried over from purification, and endotoxin where the material is intended for biological work.
The compound is most often distributed as a lyophilized powder, appearing white to off-white and forming a loose cake or fluffy solid. It is hygroscopic to some degree, so brief exposure to humid air can add water weight and complicate weighing. The peptide dissolves readily in water and in neutral aqueous buffers, and aqueous solubility is generally described as high, well above the concentrations used in typical assays. Some polar organic solvents are also usable, which matters when a concentrated stock is prepared before dilution into buffer.
Identity and purity are usually assessed by reversed-phase high-performance liquid chromatography together with mass spectrometry. The chromatogram provides a purity estimate as a percentage of total peak area, while the mass spectrum confirms that the observed mass matches the expected value. Amino acid analysis or tandem mass spectrometry sequencing can provide additional confirmation. Reported purity figures depend on the column, gradient, and detection wavelength, so values from different laboratories are not directly comparable without method details.
Lyophilised peptide is normally reconstituted with sterile water or a neutral buffer shortly before use. Because repeated freeze-thaw cycles can degrade the material, dividing a reconstituted solution into single-use aliquots is a common practice. Working solutions are usually kept cold and protected from light. The exact shelf life depends on concentration, buffer composition, and handling, so it is often determined empirically rather than assumed.
Peptide bonds are susceptible to hydrolysis under extreme pH and to enzymatic cleavage if proteases are present. Heat, oxidising agents, and prolonged exposure to light also contribute to loss of material. Aggregation can occur at high concentrations or in certain buffer systems, and it may not be visible to the eye. Storage at -20 C or below is typical for both powder and aliquoted solutions, and desiccation of the powder is preferred.
Purity and identity are separate measurements and are often confused. Reverse-phase high-performance liquid chromatography, usually with ultraviolet detection near 214 nanometres, reports the share of total peak area belonging to the target compound. Mass spectrometry by electrospray or matrix-assisted laser desorption then checks whether the observed mass matches the expected sequence. Neither measurement alone shows that a vial holds the intended peptide. Peptide content, meaning the fraction of vial mass that is genuine peptide rather than counter-ion, water or residual acid, is reported separately and is frequently lower than the stated purity figure.
The regulatory position is broadly consistent across major jurisdictions: no thymosin beta-4 fragment is an approved medicine, and laboratory material is commonly labelled as not intended for human consumption. Anti-doping rules in sport list thymosin beta-4 and its fragments among prohibited peptide hormones. Because these products travel through research-chemical channels rather than pharmaceutical supply chains, quality varies considerably between vendors. Independent testing of identity, purity and sterility is the only dependable check, and a certificate of analysis describes one batch rather than a supplier's whole catalogue.
=== Emergency approvals (EUA) === Emergency Use Authorization (EUA) is a mechanism that was created to facilitate the availability and use of medical countermeasures, including vaccines and personal protective equipment, during public health emergencies such as the Zika virus epidemic, the Ebola virus epidemic and the COVID-19 pandemic.
== Early life and education == Xing received Chinese traditional private education in his childhood. In 1933, he graduated from Fu Jen Catholic University with a diploma in Chemistry. Xing did his postgraduate work at University of Illinois at Urbana–Champaign under Roger Adams's guidance and obtained a doctorate degree in 1936. Later he went to the Ludwig-Maximilians-Universität München (LMU), conducting research on bufotoxins at Wieland's laboratory.
== Metabolism == Citalopram is metabolized in the liver mostly by CYP2C19, but also by CYP3A4 and CYP2D6. Metabolites desmethylcitalopram and didesmethylcitalopram are significantly less energetic and their contribution to the overall action of citalopram is negligible. The half-life of citalopram is about 35 hours. Approximately 80% is cleared by the liver and 20% by the kidneys. The elimination process is slower in the elderly and in patients with liver or kidney failure. With once-daily dosing, steady plasma concentrations are achieved in about a week. Potent inhibitors of CYP2C19 and 3A4 might decrease citalopram clearance. Tobacco smoke exposure was found to inhibit the biotransformation of citalopram in animals, suggesting that the elimination rate of citalopram is decreased after tobacco smoke exposure. After intragastric administration, the half-life of the racemic mixture of citalopram was increased by about 287%.
Sources: en.wikipedia.org
Characteristic properties of metals, metalloids, and nonmetals are summarized in the table. Physical properties are listed in order of ease of determination; chemical properties run from general to specific, and then to descriptive.
Reptiles tend to avoid confrontation through camouflage. Two major groups of reptile predators are birds and other reptiles, both of which have well-developed color vision. Thus the skins of many reptiles have cryptic coloration of plain or mottled gray, green, and brown to allow them to blend into the background of their natural environment. Aided by the reptiles' capacity for remaining motionless for long periods, the camouflage of many snakes is so effective that people or domestic animals are most typically bitten because they accidentally step on them. When camouflage fails to protect them, blue-tongued skinks will try to ward off attackers by displaying their blue tongues, and the frill-necked lizard will display its brightly colored frill. These same displays are used in territorial disputes and during courtship. If danger arises so suddenly that flight is useless, crocodiles, turtles, some lizards, and some snakes hiss loudly when confronted by an enemy. Rattlesnakes rapidly vibrate the tip of the tail, which is composed of a series of nested, hollow beads to ward off approaching danger. In contrast to the normal drab coloration of most reptiles, the lizards of the genus Heloderma (the Gila monster and the beaded lizard) and many of the coral snakes have high-contrast warning coloration, warning potential predators they are venomous. A number of non-venomous North American snake species have colorful markings similar to those of the coral snake, an oft cited example of Batesian mimicry.
A clinical study that includes some, but not all, of the eligible patients identified by the researchers during the study registration period. This type of study does not usually have a control group. (NCI) Non-inferiority trial
Soy protein products can be good substitutes for animal products because, unlike some other beans, soy offers a 'complete' protein profile. ... Soy protein products can replace animal-based foods—which also have complete proteins but tend to contain more fat, especially saturated fat—without requiring major adjustments elsewhere in the diet. Although soybeans have high protein content, soybeans also contain high levels of protease inhibitors, which can prevent digestion. Protease inhibitors are reduced by cooking soybeans, and are present in low levels in soy products such as tofu and soy milk. The Protein Digestibility Corrected Amino Acid Score (PDCAAS) of soy protein is the nutritional equivalent of meat, eggs, and casein for human growth and health. Soybean protein isolate has a biological value of 74, whole soybeans 96, soybean milk 91, and eggs 97.
Sources: en.wikipedia.org
No. Thymosin beta-4 is a 43-residue natural peptide, while TB-500 is a commercial label applied to a short synthetic fragment of it. The two differ in length, sequence coverage and how they are handled in the laboratory.
Published work usually examines actin binding, cell migration and tissue repair endpoints in cell and animal models. Findings are generally described as preliminary, and controlled human data remain limited.
Because TB-500 is a trade name rather than a chemical identifier, different vendors and papers may attach it to different fragment lengths. Checking the stated sequence is the practical way to resolve the ambiguity.
Divide it into single-use aliquots and hold them frozen at -20 °C or below, protected from light. Repeated thawing of one container is the main avoidable source of variability.