thymosin beta-4 is one of those subjects where the details matter more than the headlines. This page pulls together the background, the mechanisms, and the practical points readers ask about most.
Last reviewed on 2025-12-16. Where a claim depends on a specific study, the study is described rather than over-claimed.
Several names appear in scientific and commercial contexts for this peptide. The label TB-500 is informal and does not follow standard biochemical nomenclature. Research articles more often describe the compound as a thymosin beta-4 fragment, Tβ4 fragment, or by its sequence Ac-LKKTETQ. Confusing TB-500 with full-length thymosin beta-4 can lead to incorrect assumptions about activity because the fragment lacks the remaining residues of the parent protein. The relationship between fragment and parent protein remains an active area of study.
Regulatory status differs by country, but TB-500 is not an approved pharmaceutical in major jurisdictions. It is commonly sold as a research chemical for laboratory use, which places responsibility for identity and purity on the supplier and the laboratory. Published human data are limited, and most reports involve preclinical models or cell culture. Questions about whether the fragment mimics all actions of thymosin beta-4, and under which conditions, remain open. Independent verification of any material is therefore a practical requirement in research settings.
Research peptides are typically supplied as a white to off-white lyophilised powder in a sealed vial. The dry solid is more stable than a solution and is normally kept refrigerated or frozen until use. Dissolution is usually done in water, phosphate-buffered saline or a similar aqueous medium, depending on the assay. Because the material is hygroscopic and easily contaminated, opening vials in a low-humidity environment and recording the lot number before use are standard laboratory practices.
Once in solution, short peptides are generally less stable than the dry powder, and repeated freeze-thaw cycles are a common cause of loss. Laboratory guidance usually calls for aliquoting on first dissolution and storing aliquots at -20 °C or below, away from light. Adsorption to plastic and glass surfaces can lower measured concentration, particularly at low concentrations, so container material and buffer choice can affect results. Visible cloudiness, colour change or unexpected precipitate is a signal to re-check the material.
Purity is normally assessed by reversed-phase HPLC, with the main peak reported as a percentage of total peak area, while identity is confirmed by mass spectrometry. Electrospray and MALDI-TOF instruments are both used, and the observed mass is compared with the value calculated from the stated sequence. Ion-exchange or size-exclusion methods appear where aggregation or charge variants are of interest. Water content, counter-ion content and residual trifluoroacetate from purification are separate variables that can shift the measured mass and should be weighed when reading a certificate of analysis.
| Property | Value | Notes |
|---|---|---|
| Molecular formula | C38H68N10O14 | Calculated for the acetylated heptapeptide |
| Molecular weight | ~889 Da | Monoisotopic mass approximately 889.0 Da |
| Amino acid sequence | Ac-LKKTETQ | N-terminal acetylated seven-residue peptide |
| Appearance | White to off-white powder | Typically supplied as a lyophilized solid |
| Solubility class | Water-soluble | Peptides of this size generally dissolve in aqueous media |
Once dissolved, the peptide is far less stable than the dry powder. Aqueous solutions are subject to hydrolysis, oxidation at susceptible residues and gradual loss of material through adsorption onto glass and plastic surfaces. Terminal glutamine can cyclise under some conditions, producing a related species that complicates purity assessment. Dilute solutions tend to lose a larger fraction of material to surfaces than concentrated ones. Buffers, pH and ionic strength all influence the rate of change, so stability figures are only meaningful when those parameters are stated alongside the storage interval.
Detection in biological samples relies on mass spectrometry, typically liquid chromatography coupled to tandem mass spectrometry after peptide extraction and enrichment. Intact peptides can also be confirmed by high-resolution mass measurement together with fragmentation data. Detection windows in urine are short because the peptide is degraded by proteases and cleared quickly, and concentrations are low. Many jurisdictions treat the compound as a prohibited substance in sport, grouped with peptide hormones and related factors, while it is not an approved therapeutic product. Identity and purity statements therefore rest on certificates of analysis, ideally issued by an independent laboratory.
Material is normally supplied as a lyophilised powder in a sealed vial. The powder is hygroscopic, so exposure to humid air leads to water uptake, caking and gradual loss of the fluffy texture that indicates a good freeze-dry. Vials are best kept sealed with desiccant, protected from light and stored cold. Letting a cold vial warm to room temperature before opening reduces condensation on the contents. Purity is normally reported from a chromatographic run, and that figure applies to the batch as tested rather than to the vial after repeated opening.
Interest in the compound comes largely from studies of the parent protein, which participates in actin sequestration, cell migration and tissue repair processes. Whether a short fragment reproduces those activities is a separate question that remains open in the published record. Many summaries describe mechanisms by analogy to thymosin beta-4 rather than from direct measurements on the fragment. Claims about activity should be treated as provisional unless a cited study specifies the exact peptide, its purity and the assay used.
TB-500 is a laboratory label applied to a short synthetic peptide that is widely described as a fragment of thymosin beta-4, an actin-binding protein present in most mammalian cells. Suppliers and review articles usually present TB-500 as the N-terminal region of that protein, but the exact sequence attached to the name is not consistent across sources. Some product descriptions list a seven-residue chain; others use the label loosely for the parent protein itself. Because of that variation, any technical discussion of TB-500 needs to state which sequence is meant.
Thymosin beta-4 contains 43 amino acids and has a reported molecular mass near 4963 Da. The short fragment most often associated with the TB-500 label, an acetylated chain beginning LKKTETQ, has a reported mass near 889 Da, so the two are easily separated in analytical work. Mass spectrometry and amino acid analysis can confirm which material is present in a given sample. Statements treating TB-500 and thymosin beta-4 as interchangeable are therefore imprecise, even though the two appear together in much of the same literature.
== Further reading == Inglis, Julia J.; Criado, Gabriel; Medghalchi, Mino; Andrews, Melanie; Sandison, Ann; Feldmann, Marc; Williams, Richard O. (29 October 2007). "Collagen-induced arthritis in C57BL/6 mice is associated with a robust and sustained T-cell response to type II collagen". Arthritis Research & Therapy. 9 (5): R113. doi:10.1186/ar2319. ISSN 1478-6354. PMC 2212575. PMID 17967186. Pietrosimone, K. M.; Jin, M.; Poston, B.; Liu, P. (20 October 2015). "Collagen-Induced Arthritis: A model for Murine Autoimmune Arthritis". Bio-Protocol. 5 (20) e1626. doi:10.21769/bioprotoc.1626. ISSN 2331-8325. PMC 4629450. PMID 26539560. Holmdahl, Rikard; Bockermann, Robert; Bäcklund, Johan; Yamada, Hisakata (1 February 2002). "The molecular pathogenesis of collagen-induced arthritis in mice—a model for rheumatoid arthritis". Ageing Research Reviews. 1 (1): 135–147. doi:10.1016/S0047-6374(01)00371-2. ISSN 1568-1637. PMID 12039453. S2CID 28243127.
== Proliferative phase == About two or three days after the wound occurs, fibroblasts begin to enter the wound site, marking the onset of the proliferative phase even before the inflammatory phase has ended. As in the other phases of wound healing, steps in the proliferative phase do not occur in a series but rather partially overlap in time.
Thorium is a chemical element; it has symbol Th and atomic number 90. Thorium is a weakly radioactive light silver metal which tarnishes olive grey when it is exposed to air, forming thorium dioxide; it is moderately soft, malleable, and has a high melting point. Thorium is an electropositive actinide whose chemistry is dominated by the +4 oxidation state; it is quite reactive and can ignite in air when finely divided. All known thorium isotopes are unstable. The most stable isotope, 232Th, has a half-life of 14.0 billion years, or about the age of the universe; it decays very slowly via alpha decay, starting a decay chain named the thorium series that ends at stable 208Pb. On Earth, thorium and uranium are the only elements with no stable or nearly-stable isotopes that still occur naturally in large quantities as primordial elements. Thorium is estimated to be over three times as abundant as uranium in the Earth's crust, and is chiefly refined from monazite sands as a by-product of extracting rare-earth elements. Thorium was discovered in 1828 by the Swedish chemist Jöns Jacob Berzelius during his analysis of a new mineral found by Morten Thrane Esmark in Norway on Løvøya island near Brevik in the Langesund fjord. He named it after Thor, the Norse god of thunder and war. Its first applications were developed in the late 19th century. Thorium's radioactivity was widely acknowledged during the first decades of the 20th century. In the second half of the 20th century, thorium was replaced in many uses due to concerns about its radioactive properties.
Sources: en.wikipedia.org
The Bowery Mural is an outdoor exhibition space located on the corner of Houston Street and the Bowery, on a wall owned by Goldman Properties since 1984. Real estate developer Tony Goldman began the project with Jeffery Deitch and Deitch Projects in 2008. Goldman's goal was to use this wall to present the top contemporary artists from around the world, with an emphasis on artists who work on the streets. Seasonal murals have appeared on the wall curated and organized in collaboration with The Hole, NYC, an art gallery in SoHo run by former Deitch Projects directors Kathy Grayson and Meghan Coleman. The mural series was initiated from March to December 2008 with a tribute to Keith Haring’s noted 1982 Bowery mural. This was followed by a mural by the Brazilian twin-brother duo Os Gêmeos, which they dedicated to artist Dash Snow, who had recently died from a drug overdose; this was presented from July 2009 to March 2010. The next mural, by Shepard Fairey, was on exhibit from April through August 2010, and was followed by a mural by Barry McGee which celebrated the role of graffiti tagging in the history of New York City street art; it was on display from August to November 2010. This was followed by a tribute to Dash Snow by Irak, which ran from November 24–26, 2010. Other artists to have murals presented include the twins How & Nosm (2012), Crash (2013), Martha Cooper (2013), Revok and Pose (2013), Swoon (2014), and Maya Hayuk.
=== Reagents === Phenol: The phenol used for biochemistry comes as a water-saturated solution with Tris buffer, as a Tris-buffered 50% phenol, 50% chloroform solution, or as a Tris-buffered 50% phenol, 48% chloroform, 2% isoamyl alcohol solution (sometimes called "25:24:1"). Phenol is naturally somewhat water-soluble, and gives a fuzzy interface, which is sharpened by the presence of chloroform, and the isoamyl alcohol reduces foaming. Most solutions also have an antioxidant, as oxidized phenol damages the nucleic acids. For RNA purification, the pH is kept at around 4, which retains RNA in the aqueous phase preferentially. For DNA purification, the pH is usually near 7, at which point all nucleic acids are found in the aqueous phase. Chloroform: Chloroform is stabilized with small quantities of amylene or ethanol, because exposure of pure chloroform to oxygen and ultraviolet light produces phosgene gas. Some chloroform solutions come as pre-made a 96% chloroform, 4% isoamyl alcohol mixture that can be mixed with an equal volume of phenol to obtain the 25:24:1 solution. Isoamyl alcohol: Isoamyl alcohol may reduce foaming and ensure deactivation of RNases.
Activated carbon can be manufactured from carbonaceous material, including coal (bituminous, subbituminous, and lignite), peat, wood, or nutshells (e.g., coconut). The manufacturing process consists of two phases: carbonization and activation. The carbonization process includes drying and then heating to separate by-products, including tars and other hydrocarbons from the raw material, as well as to drive off any gases generated. The process is completed by heating the material over 400 °C (750 °F) in an oxygen-free atmosphere that cannot support combustion. The carbonized particles are then "activated" by exposing them to an oxidizing agent, usually steam or carbon dioxide, at high temperature. This agent burns off the pore-blocking structures created during the carbonization phase, and so they develop a porous, three-dimensional graphite lattice structure. The size of the pores developed during activation is a function of the time that they spend in this stage. Longer exposure times result in larger pore sizes. The most popular aqueous phase carbons are bituminous based because of their hardness, abrasion resistance, pore size distribution, and low cost, but their effectiveness needs to be tested in each application to determine the optimal product. Activated carbon is used for adsorption of organic substances and non-polar adsorbates and it is also usually used for waste gas (and waste water) treatment. It is the most widely used adsorbent since most of its chemical (e.g. surface groups) and physical properties (e.g.
=== 14 April === One person was killed in a Russian airstrike in Donetsk Oblast. Another person was killed by Russian shelling in Sumy Oblast. Russia claimed that it had shot down all ten drones launched by Ukraine at Krasnodar Krai.
Sources: en.wikipedia.org
TB-500 is a synthetic heptapeptide corresponding to a fragment of thymosin beta-4. It is used in laboratory research and is not an approved drug.
No. Thymosin beta-4 is a 43-amino-acid protein, while TB-500 represents only a short N-terminal segment. The two should not be treated as interchangeable in experimental design.
It is often called a thymosin beta-4 fragment, Tβ4 fragment, or Ac-LKKTETQ. The name TB-500 is mainly a commercial or catalog label rather than a formal chemical name.
Sealed, desiccated and protected from light, at -20 °C or lower for long-term storage. Short-term storage at refrigerator temperature is common in working laboratories.