This is a working overview of reconstitution, written for readers who want more than a one-paragraph summary but less than a textbook.
This page was last updated on 2026-01-15 and is reviewed periodically as new material appears.
No major regulatory agency has approved TB-500 for therapeutic use, and it holds no pharmacopoeial monograph. The name appears on the World Anti-Doping Agency prohibited list within the class covering peptide hormones, growth factors, and related substances. Detection in doping control relies on mass spectrometric methods applied to urine, often after preparation steps that concentrate the analyte. Discussion of TB-500 therefore clusters in biochemistry, sports medicine, and anti-doping literature rather than in registered clinical trials.
TB-500 is a synthetic peptide preparation marketed under a name derived from thymosin beta-4, a 43-residue actin-binding protein first isolated from thymus tissue. The full-length protein has a reported molecular mass near 4963 Da, while material sold as TB-500 is often described as a fragment containing the actin-binding motif LKKTETQ. Because suppliers use the name inconsistently, published sources sometimes refer to the same label as a fragment, a synthetic copy, or a related analog. This naming ambiguity complicates direct comparison of reports across studies.
Dry powder is commonly held at minus twenty degrees Celsius, with some suppliers recommending lower temperatures for long-term archival storage. Once dissolved, solutions are typically kept cold and protected from light, since aqueous peptide solutions can lose integrity through hydrolysis or oxidation over time. Stability data specific to this fragment are limited in the public literature, and much of the guidance comes from general peptide handling practice rather than from controlled degradation studies. Users therefore treat stated shelf lives as approximate rather than fixed.
Identity and purity are normally assessed with reversed-phase high-performance liquid chromatography, paired with mass spectrometry to confirm molecular mass. A certificate of analysis reports a purity percentage, usually derived from chromatographic peak area, but that figure does not by itself prove a correct sequence or the absence of counterions. Independent verification may include amino acid analysis or peptide mapping. Batch-to-batch variation is a documented concern in the research chemical market, and the gap between a quoted purity value and actual peptide content can be substantial when the material is a salt or retains residual water.
| Property | Value | Notes |
|---|---|---|
| Molecular mass | Approximately 4963 Da for full-length thymosin beta-4 | Value applies to the parent protein; fragment products may differ |
| Appearance | White to off-white lyophilized powder | Typical form of supplied synthetic peptide |
| Solubility | Freely soluble in water | Polar peptide; dissolves readily in aqueous buffer |
| Storage of dry powder | −20 °C, desiccated, protected from light | Standard laboratory practice for peptides |
| Typical detection method | Liquid chromatography–tandem mass spectrometry | Used in purity testing and anti-doping analysis |
Discussion of the compound frequently appears alongside other short peptides described as fragments of larger proteins. That grouping is convenient but can be misleading, because fragment length, charge, and modification state determine how a peptide behaves in solution and in any experimental system. A seven-residue acetylated peptide and a full-length protein differ in mass by roughly an order of magnitude, and they cannot be assumed to share distribution or binding properties. Precision about which molecule is under discussion is the single most useful step when reading such material.
TB-500 is a shorthand label used in supplier catalogs and online discussion for a short synthetic peptide described as a fragment of thymosin beta-4. Most product listings present it as the N-terminally acetylated heptapeptide Ac-LKKTETQ, a sequence corresponding to the actin-binding region of the parent protein. The name is not a formal chemical designation and does not appear in standard nomenclature systems. Because labeling practices vary between vendors, two products sold under the same name may not contain the same molecule, and the stated sequence should be treated as a claim rather than a fixed definition.
The compound circulates in the literature as a research reagent rather than an approved therapeutic. Regulatory agencies in several countries have not authorized it for medical use, and sporting bodies list related thymosin beta-4 peptides among prohibited substances. Suppliers typically market it with a purity figure and a certificate of analysis, while peer-reviewed clinical reports remain sparse. Discussions therefore often separate laboratory findings from anecdotal reports, and reviewers tend to note the small size and methodological limits of the available studies.
TB-500 refers to a synthetic peptide fragment derived from the actin-binding region of thymosin beta-4, a protein present in most mammalian cells. The full protein contains forty-three amino acids, while the commonly sold fragment is a much shorter acetylated sequence, often cited as LKKTETQ. The fragment retains part of the actin-binding motif but lacks the remainder of the parent protein. Material sold under this name is usually lyophilized powder intended for laboratory research, and it is not a finished pharmaceutical product.
Identity and purity are checked with reversed-phase high-performance liquid chromatography, which separates the target sequence from truncated or deletion analogues, and with mass spectrometry, which confirms the expected molecular mass. Amino acid analysis and peptide mapping give orthogonal confirmation but are used less often outside specialist laboratories. Counter-ion content varies: material purified on trifluoroacetic acid gradients retains trifluoroacetate, and ion exchange can convert the salt form. Residual water and solvent are measured by Karl Fischer titration or thermogravimetric analysis, and any purity figure should be read together with the method used to obtain it.
Lyophilised peptide powders are hygroscopic, and the fragment absorbs atmospheric moisture when a vial is opened at room temperature. Weighing and aliquoting are normally done quickly in a dry environment, and stock solutions are divided into single-use portions before freezing. Repeated freeze-thaw cycles are avoided because they promote aggregation and can shift the measured content of a vial. These practices are general to synthetic peptides rather than unique to this sequence, but they matter more for short chains kept for long periods.
The seven-residue chain carries several polar and charged side chains, so it dissolves readily in water and in aqueous buffers near neutral pH. No cysteine is present, so disulphide formation is not a concern and reducing agents are unnecessary. Dilute ammonium hydroxide or acetonitrile-water mixtures are sometimes used for stock solutions when initial dissolution is slow. Strongly alkaline conditions and prolonged contact with oxidising agents are avoided because they can modify lysine-containing stretches, and haze in solution usually signals incomplete dissolution or aggregated material.
Peptide bonds are susceptible to hydrolysis under extreme pH and to enzymatic cleavage if proteases are present. Heat, oxidising agents, and prolonged exposure to light also contribute to loss of material. Aggregation can occur at high concentrations or in certain buffer systems, and it may not be visible to the eye. Storage at -20 C or below is typical for both powder and aliquoted solutions, and desiccation of the powder is preferred.
Identity and purity are usually assessed by reversed-phase high-performance liquid chromatography together with mass spectrometry. The chromatogram provides a purity estimate as a percentage of total peak area, while the mass spectrum confirms that the observed mass matches the expected value. Amino acid analysis or tandem mass spectrometry sequencing can provide additional confirmation. Reported purity figures depend on the column, gradient, and detection wavelength, so values from different laboratories are not directly comparable without method details.
Lyophilised peptide is normally reconstituted with sterile water or a neutral buffer shortly before use. Because repeated freeze-thaw cycles can degrade the material, dividing a reconstituted solution into single-use aliquots is a common practice. Working solutions are usually kept cold and protected from light. The exact shelf life depends on concentration, buffer composition, and handling, so it is often determined empirically rather than assumed.
Antithrombin is a serpin (serine protease inhibitor) and is thus similar in structure to most other plasma protease inhibitors, such as alpha 1-antichymotrypsin, alpha 2-antiplasmin and Heparin cofactor II. The physiological target proteases of antithrombin are those of the contact activation pathway (formerly known as the intrinsic pathway), namely the activated forms of Factor X (Xa), Factor IX (IXa), Factor XI (XIa), Factor XII (XIIa) and, to a greater extent, Factor II (thrombin) (IIa), and also the activated form of Factor VII (VIIa) from the tissue factor pathway (formerly known as the extrinsic pathway). The inhibitor also inactivates kallikrein and plasmin , also involved in blood coagulation. However it inactivates certain other serine proteases that are not involved in coagulation such as trypsin and the C1s subunit of the enzyme C1 involved in the classical complement pathway. Protease inactivation results as a consequence of trapping the protease in an equimolar complex with antithrombin in which the active site of the protease enzyme is inaccessible to its usual substrate. The formation of an antithrombin-protease complex involves an interaction between the protease and a specific reactive peptide bond within antithrombin. In human antithrombin this bond is between arginine (arg) 393 and serine (ser) 394 (see Figure 2 and Figure 3). It is thought that protease enzymes become trapped in inactive antithrombin-protease complexes as a consequence of their attack on the reactive bond.
Lectins from legume plants, such as PHA or concanavalin A, have been used widely as model systems to understand the molecular basis of how proteins recognize carbohydrates, because they are relatively easy to obtain and have a wide variety of sugar specificities. The many crystal structures of legume lectins have led to a detailed insight of the atomic interactions between carbohydrates and proteins. Legume seed lectins have been studied for their insecticidal potential and have shown harmful effects for the development of pest.
A carbohydrate () is a sugar (saccharide), a polysaccharide such as starch, or a derivative of these compounds. For many carbohydrates such as simple sugars, the carbon-to-hydrogen-to-oxygen atomic ratio is 1:2:1 so their empirical formula is CH2O and their molecular formulas have the form Cn(H2O)n. Along with amino acids, fats, and nucleic acids, the carbohydrates are one of the major families of biomolecules. Carbohydrates perform numerous roles in living organisms. Polysaccharides serve as an energy store (e.g., starch and glycogen) and as structural components (e.g., cellulose in plants and chitin in arthropods and fungi). The 5-carbon monosaccharide ribose is an important component of coenzymes (e.g., ATP, FAD and NAD) and the backbone of the genetic molecule known as RNA. The related deoxyribose is a component of DNA. Saccharides and their derivatives play key roles in the immune system, fertilization, preventing pathogenesis, blood clotting, and development. Carbohydrates are central to nutrition and are found in a wide variety of natural and processed foods. Starch is a polysaccharide and is abundant in cereals (wheat, maize, rice), potatoes, and processed food based on cereal flour, such as bread, pizza or pasta. Sugars appear in the human diet mainly as table sugar (sucrose, extracted from sugarcane or sugar beets), lactose (abundant in milk), glucose and fructose, both of which occur naturally in honey, many fruits, and some vegetables. Table sugar, milk, or honey is often added to drinks and many prepared foods such as jam, biscuits, scones and cakes.
== Mechanism of plasminogen activation == Full length plasminogen comprises seven domains. In addition to a C-terminal chymotrypsin-like serine protease domain, plasminogen contains an N-terminal Pan Apple domain (PAp) together with five Kringle domains (KR1-5). The Pan-Apple domain contains important determinants for maintaining plasminogen in the closed form, and the kringle domains are responsible for binding to lysine residues present in receptors and substrates. The X-ray crystal structure of closed plasminogen reveals that the PAp and SP domains maintain the closed conformation through interactions made throughout the kringle array . Chloride ions further bridge the PAp / KR4 and SP / KR2 interfaces, explaining the physiological role of serum chloride in stabilizing the closed conformer. The structural studies also reveal that differences in glycosylation alter the position of KR3. These data help explain the functional differences between the type I and type II plasminogen glycoforms. In closed plasminogen, access to the activation bond (R561/V562) targeted for cleavage by tPA and uPA is blocked through the position of the KR3/KR4 linker sequence and the O-linked sugar on T346. The position of KR3 may also hinder access to the activation loop. The Inter-domain interactions also block all kringle ligand-binding sites apart from that of KR-1, suggesting that the latter domain governs pro-enzyme recruitment to targets.
Sources: en.wikipedia.org
== Use == The bifurcated needle is a narrow steel rod, approximately 5 cm (2 in) long with two prongs at one end. Between the two needle prongs, it can hold one dose of reconstituted freeze-dried smallpox vaccine. Up to one hundred vaccinations can be given from one vial of the reconstituted vaccine. The established technique for smallpox vaccination is to dip the needle in the vaccine, and then perpendicularly puncture a person's upper arm fifteen times rapidly in a small circular area. Though skin in the area should be clean, use of an alcohol swab is optional and if used the skin must be allowed to fully dry to avoid deactivation of the live virus vaccine. The punctures should remain in an area approximately 5 mm in diameter. The needle is then disposed of or can be sterilized for reuse given its entirely metal construction. When vaccination has been done correctly, a trace of blood appears at the vaccination site within 10 to 20 seconds after the procedure.
A Taylor cone refers to the cone observed in electrospinning, electrospraying and hydrodynamic spray processes from which a jet of charged particles emanates above a threshold voltage. Aside from electrospray ionization in mass spectrometry, the Taylor cone is important in field-emission electric propulsion (FEEP) and colloid thrusters used in fine control and high efficiency (low power) thrust of spacecraft.
Hong Kong is represented in the National People's Congress by 36 deputies chosen through an electoral college and 203 delegates in the National Committee of the Chinese People's Political Consultative Conference appointed by the central government.
=== Attenuance === Absorbance is a number that measures the attenuation of the transmitted radiant power in a material. Attenuation can be caused by the physical process of "absorption", but also reflection, scattering, and other physical processes. Absorbance of a material is approximately equal to its attenuance when both the absorbance is much less than 1 and the emittance of that material (not to be confused with radiant exitance or emissivity) is much less than the absorbance. Indeed,
adenosine monophosphate (AMP) A nucleoside consisting of adenosine attached to a single phosphate group via a high-energy ester bond. Additional phosphate groups can be added to AMP to produce ADP and ATP; the cyclic ester of AMP serves as a second messenger in some signaling pathways.
Sources: en.wikipedia.org
Not necessarily. TB-500 is a commercial label that suppliers apply to synthetic peptides described as thymosin beta-4 or a fragment of it. Published research most often studies the full-length protein, so statements about one do not automatically transfer to the other.
No. No major regulatory authority lists an approved product under this name, and no pharmacopoeial monograph exists for it. Material sold under the label is therefore supplied outside approved pharmaceutical channels, which affects the quality documentation available.
It falls within a prohibited class covering peptide hormones and growth factors, based on presumed effects on tissue repair and blood vessel formation. Anti-doping laboratories have published mass spectrometry methods for detecting thymosin beta-4 related peptides in urine samples.
Dry lyophilized powder is usually kept frozen, desiccated, and out of direct light. Sealed vials are not opened until needed, because moisture uptake can degrade short peptides. Longer archival storage is often done at lower temperatures than routine working stock.